Centre
Quality Knowledge Centre
Vendor-neutral hub for apparel quality planning, inspection, testing, SPC/Six Sigma, CAPA, First-Time-Right and measurement control.
Starter details
- Detail
AQL Inspection
Acceptance Quality Limit sampling for finished-garment inspection — sampling plans, sample selection, defect classification and lot disposition.
- Detail
Product Testing & Laboratory Control
Physical, colour and seam performance testing plus laboratory governance — from test-plan selection to method validation, calibration and result release.
- Detail
SPC & Six Sigma (DMAIC)
Statistical process control and Six Sigma DMAIC applied to garment manufacturing — control charts, process capability and structured improvement.
- Detail
CAPA — Root Cause & Prevention
Full CAPA cycle for apparel manufacturing: containment, root-cause analysis, corrective action, preventive/system action, effectiveness verification and recurrence prevention.
- Detail
First-Time-Right Guide
Design and operate a First-Time-Right (FTR) programme in apparel manufacturing — pre-production readiness, poka-yoke controls and in-line verification to reduce rework, DHU and shipment slippage.
- Detail
Garment Measurement Control
Vendor-neutral guide to garment measurement discipline — points of measure (POM), tolerance frames, measurement-system analysis and in-line audit — anchored to buyer specifications.
Focus areas
- AQL sampling and inspection discipline
- Product testing and laboratory control
- SPC, DMAIC and process capability
- CAPA and recurrence prevention
- First-Time-Right (FTR)
- Garment measurement control
Learn with GarmentEd
- GarmentEd lesson
AQL Inspection
Open the GarmentEd lesson.
- GarmentEd lesson
SPC and Control Charts
Open the GarmentEd lesson.
- GarmentEd lesson
Process Capability
Open the GarmentEd lesson.
- GarmentEd lesson
Measurement Audit
Open the GarmentEd lesson.
- GarmentEd lesson
Corrective and Preventive Action
Open the GarmentEd lesson.